

Coil Master 521 Tab Plus
Uses one or two 18650 batteries. (Not included)
A must have for any RBA/RDA vaper who makes their own coils. This 521 TAB Plus is a total redesign, but ofcourse with the same features as before.
The Coil Master 521 Tab Plus is the one tool that will make the life of any DIY vaper not only easier but also much more fun.
It hides a whole range of features in the box.
First it's simply a brilliant base for building your RBA on. The sturdy box is made from ABS Thermoplastics and stainless steel, and is a brilliant platform for putting your coil in your tank.
Second it will burn your coil, allowing you to squeeze a micro coil without having to put your tank on a Mod.
It will then let you measure the Ohm of your new coil so you can check the exact resistance. The Coil Master 521 Tab Plus will meassure from 0.03 to 9.99 Ohm.
No need to remove the tank from the box.
You switch between Ohm meter and Burn-mode by using the small switch on the side.
However, even this is not all.
By attatching the Volt meassuring unit on top of the Coil Master 521 Tab Plus, you can check the Voltage of your Mod by using the 510 connector.
As a final treat, you also get a wire with banana plugs and alligator clips you can meassure the exact resistance of any piece of wire.
Don't say we didn't tell you: The Coil Master 521 Tab Plus is a truly magical box that will change your life af a coil-smith.
The Coil Master 521 Tab Plus can be used in single or dual 18650 battery setup. (sold separately)